Voltage Specification - Flash Big Eye User Manual

User Manual • Instrukcja Obsługi

5.2 Voltage specification

Input Voltage
100~245V
5.3 Connecting power supply
The connection is performed using
power cable with PowerCon connector
( i n c l u d e d ) . T h e d e v i c e m u s t b e
operated by qualified personnel.
Total Power
CAUTION! In the case of cable damage do not attempt to repair.
Replacement or repair can be made only on the manufacturer or by
a person with appropriate permissions.
Using lamp, the change rate of power voltage should be within
± 10%, if the voltage is too high, it will shorten the light's life; if it's
not enough, the lamp will be dark. Please restart it after turning
off light for 20 minutes until full-cooling. Frequent switching will
reduce the life span of lamps and bulbs; intermittent using will
improve the life of bulbs and lamps.
MENU MAP
1. System Setup
Run Mode
DMX Address
Channel Mode
Invert Pan
Invert Tilt
Pan-Tilt Swap
Encoder
No signal
Screen Saver
Language
Load Default
2. Manual Drive
3. Motor Calibration
PAN
4. System Test TILT
5. System Info ZOOM
ROTATION
300W
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not
exceeded.
DMX / Sound / Auto 3 / Auto 2 / Auto 1 / ART
001-255
17 Ch (Standard) / 32 Ch (Extend) / 89 Ch (Full)
OFF / ON
OFF / ON
OFF / ON
ON / OFF
Clean / Keep
ON / OFF
EN / CH
1. Pan
2. Pan Fine
3. Tilt
4. Tilt Fine
5. P-T Speed
6. Zoom
7. Rotation
8. Dimmer
9. Strobe
10. Red
11. Green
12. Blue
13. White
14. Linear CTO
15. Macro Colour
16. Static Effect
17. Shape
18. Shape Speed
19. Background R
20. Background G
21. Background B
22. Background W
23. Reset
Frequency
50/60Hz