Table of Contents
Advertisement
Fault
lights up.
"H:95" lights up altern-
ately with End.
All other error codes.
The appliance is not
working.
The programme does
not start.
Cause and troubleshooting
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 32
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 26
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Drum cleaning is required.
→ "Cleaning the drum", Page 37
▶
The water pressure is low.
See
▶
→ "
", Page 43
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 52
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed
Press
.
▶
Door is not closed.
Close the door.
1.
Troubleshooting en
.
43
Advertisement
Table of Contents
