Table of Contents
Advertisement
INSTRUCTIONS (CONT.)
Side PIR Sensor
The two side PIR sensor zones provide a wide detection angle and detect more
potential triggers. Sometimes you may only wish to observe a certain point. Too many
irrelevant triggers from the side sensor zones outside of this point continuously switch
the Wildlife Camera on and off, considerably affecting battery life. In some situations,
it may be difficult to remove interfering branches or avoid sun light. In these situations,
you can switch off the side PIR sensors. The default setting for the side PIR sensors is
'On'. Refer to the steps below for how to turn the side PIR sensors 'On' and 'Off'.
SHOT
1.
Slide the power/mode switch to SETUP.
MODE
2.
Press the MENU button to access the menu options and settings.
SHOT
3.
Use the
or
MODE
4.
Press the OK button to select 'Side PIR' from the menu.
5. Use the
or
6. Press the OK button to confirm your selection.
7.
Press the MENU button to exit the menu and return to the viewing screen.
PIR Sensitivity
The higher the sensitivity, the easier the motion sensor will be triggered. It is
recommended to set the PIR sensitivity to 'medium' mode. The sensitivity of PIR
is strongly related to the temperature. The higher the temperature, the lower the
sensitivity of the PIR. The default setting for the PIR sensitivity is 'High'. Refer to the
steps below for how to change the PIR sensitivity.
SHOT
1.
Slide the power/mode switch to SETUP.
MODE
2.
Press the MENU button to access the menu options and settings.
SHOT
3.
Use the
or
MODE
4.
Press the OK button to select 'PIR sensitivity' from the menu.
5. Use the
or
'low' or 'auto'.
6. Press the OK button to confirm your selection.
7.
Press the MENU button to exit the menu and return to the viewing screen.
AFTER SALES SUPPORT
1300 777 137
SHOT
SHOT
SHOT
MODE
MODE
MODE
SHOT
buttons to navigate the menu.
SHOT
SHOT
MODE
MODE
MODE
buttons to select 'On' or 'Off'.
SHOT
SHOT
SHOT
MODE
MODE
MODE
SHOT
buttons to navigate the menu.
SHOT
SHOT
MODE
MODE
MODE
buttons to navigate the PIR sensitivity options: 'high', 'medium',
MODEL: EA2204 PRODUCT CODE: 708149 04/2022
service@unclebills.com.au
25
Advertisement
Table of Contents
Need help?
Do you have a question about the EA2204 and is the answer not in the manual?