Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Pahlen MiniMaster
Summary of Contents for Pahlen MiniMaster
- Page 1 Swedish design and manufacture since 1967 MiniMaster Manual User manual Инструкция Manuel d’utilisation Handboek Copyright © 2011 Pahlén AB, Box 728, SE-194 27 Upplands Väsby, Sweden Tel. +46 8 594 110 50, Fax +46 8 590 868 80, e-mail: info@pahlen.se, www.pahlen.com...
-
Page 2: Product Description
1. Product description MiniMaster is an electronic unit that monitors and controls the pH value and/or chlorine levels in a swimming pool. The pH value is measured using a pH electrode, whilst chlorine levels are measured using a free chlorine electrode. -
Page 3: Installation
MiniMaster, and for dosing points for liquid acid and chlorine via hose pumps. A flexible PVC hose (included) must run between the MiniMaster and pre-filter. A rigid PE hose (included) must run between the pre-filter and the pipes. -
Page 4: Electrical Installation
ENGLISH MiniMaster 7. Electrical installation The electrical installation must always be carried out by a qualified electrician. The pipe installation must be complete before the electrical installation begins. It is recommended that a power switch is fitted before the unit in permanent installations. Interlocked supply voltage from circulation pump. -
Page 5: Start Preparation
(see “Recommended values...” in section 3 General information). 9. Once the values for both pH and free chlorine are in balance at the same time, you may continue and calibrate the MiniMaster. Each unit must be calibrated separately. The operate independently of each other. -
Page 6: Operation
The green LED indicates MiniMaster calibrated value (everything is OK). Yellow/red LED indicate deviation from calibrated value, see table below. Flashing LEDs indicate that the MiniMaster is measuring, with the speed of the flashing showing whether or not dosing has been activated, for more information, read under “LEDs” on the next page. - Page 7 When power to the MiniMaster is switched on, a start sequence begins after about 2 seconds and the LEDs (1-7) come on in sequence, after which the set mode is displayed (see point 5 below).
- Page 8 13. Maintenance • When rinsing the pool sand filter – close the shut-off valves (L1 and L2) on the pre-filter running to and from the MiniMaster. • Check the flow by pressing button (F) – adjust to the correct flow using set screw (H) on the start module.
-
Page 9: Troubleshooting
L2 (see Figure 1) carefully until the green LED (flow OK) comes on. Reservations We accept no liability for printing errors. We reserve the right to make changes to MiniMaster technical specifications or its manual. Colour differences may occur due to technical factors in the printing process.
Need help?
Do you have a question about the MiniMaster and is the answer not in the manual?
Questions and answers