Installing The Indoor Unit - Lamborghini Caloreclima RUBINO PLUS 7 Use And Maintenance Manual

2.3 INSTALLING THE INDOOR UNIT

Choice of place of installation. In compliance with the conditions indicated in the "Installation Diagrams" section, reported in the ma-
nual of the outdoor units. position the unit as low as possible, leaving 15 cm of free space over the unit. It is recommended to observe
the spaces indicated in the figure "fig. 7 -". Before fixing it to the wall, check that the wall can withstand the weight of the unit, that the
air flow is not obstructed by curtains and the like and that the position is suitable for guaranteeing optimum diffusion of air in the room.
Installation. After choosing where to position the indoor unit, use the fixing plate as a template in order to find the exact position for the
expansion plugs and for the hole through the wall. The overall space required for installation must be considered. The plastic casing
of the unit features pre-cut sections that, if necessary, can be removed to allow the refrigerant lines and cables to be passed through.
Mod. 7-9
Mod. 12
24
EN
fig. 7 -
fig. 8 -
fig. 9 -
Cod. 3QE46190 - Rev. 01 - 10/2020
RUBINO PLUS
Shape
internal unit
Shape
internal unit