Table of Contents
Advertisement
9.5 Heating in temperature
& speed mode
Schaeffler Technologies
■ Heating runs until the set temperature is reached or until the
set time has elapsed, whichever comes first. The workpiece
is then demagnetized automatically and a loud, continuous
beep sounds. Press "STOP" to switch off the beep.
■ Position the workpiece and any sensors (according to
chapters 7 & 8.)
■ Switch on the heater and select the temperature & speed
mode if necessary.
■ If necessary, change the temperature and gradient set by
pressing the current values.
■ Press "START". The heating starts, you will hear a slight
humming sound.
■ The display shows the current temperature of
the workpiece.
■ If a second sensor is attached to the workpiece, this
temperature also appears on the display.
By pressing the info button
displayed graphically.
The white dotted line indicates the gradient at which the
process is set. Pressing info again displays additional
information from the process.
, the heating process is
37
Advertisement
Table of Contents
