Certification Instructions - Emerson Rosemount 935 Reference Manual

Reference Manual
00809-0100-4035
• Alignment tool kit
• Function check filters
• HART
Other accessories are available (per customer request):
• 5-in pole mount kit
• 2 to 3-in pole mount
• Wall mount
• Protective cover
Note
See the
4.3.2 Unpacking
Upon receipt of your device, verify the appropriate purchase order.
In addition:
• Record the part number and the serial number of the detectors and source units and
the installation date in the appropriate log book.
• Open the container package immediately prior to detector installation and visually
inspect the detectors, sources, and accessories.
• Verify that all components required for detector installation are readily available before
commencing the installation. In the event that the installation is not completed in a
single session, secure and seal detectors and conduits.
4.4

Certification instructions

WARNING
EXPLOSION
Do not open the detector, even when isolated, in a flammable atmosphere.
• The cable entry point may exceed 182 °F (83 °C). Take suitable precautions when
selecting the cable.
• The equipment may be used with flammable gases and vapors with apparatus groups
IIA and IIB+H2 T4 in the ambient temperature range: -67 °F (-55 °C) to 149 °F (65 °C).
• Only suitably trained personnel shall install the detector in accordance with the
applicable code of practice, e.g., EN 60079-14: 1997.
• Only suitably trained personnel shall inspect and maintain this equipment in
accordance with the applicable code of practice, e.g., EN 60079-19.
• Only suitably trained personnel shall repair this equipment in accordance with the
applicable code of practice, e.g., EN 60079-19.
Rosemount 935
®
hand-held harness kit
Rosemount 935 Product Data Sheet for accessory part numbers.
Installation
May 2022
27