Crestron FlipTop FT2 Series Quick Start Manual page 3

FT2-700-ELEC-PTL
FlipTop™ FT2 Series Cable Management System, 700 Size, Electrical, Pass-Through Lid
Secure the FlipTop Assembly
To prepare the FT2-700-ELEC-PTL and secure it to the table surface:
1. Gently remove the bezel before securing the FT2 assembly to the
table. It is held in place with magnets.
2. Locate the included DC power splitter cable.
3. On the underside of the FT2 assembly, locate the power bus and
connect the dual-connector ends of the DC power splitter cable to
the two barrel jacks of the power bus. The cable will be accessed later
in Connect the FlipTop Assembly.
4. Ensure that all four swiveling dogs are tucked inside of the FT2
assembly, and then insert the FT2 assembly into the mounting hole
until the top lip is flush with the table surface.
Quick Start
3