Crestron FlipTop FT2 Series Quick Start Manual page 2

FT2-700-ELEC-PTL
FlipTop™ FT2 Series Cable Management System, 700 Size, Electrical, Pass-Through Lid
Mount the FlipTop Assembly
A mounting hole is required for an FT2-700-ELEC-PTL installation. Use
the included template to cut a mounting hole for new installations. The
FT2-700-ELEC-PTL may also replace an FT-600 FlipTop or Extron®
Cable Cubby® 700 Cable Access Enclosure using the existing mounting
hole.
When determining the location for the FT2 assembly, consider where
users will be seated and their proximity to the FT2 assembly's modules
and retractors. Refer to the FT2A-CBLR-1T
cable retractors for above-the-table cable pull-out lengths.
For a new mounting, follow sections
the FlipTop Assembly. To use the mounting hole of an existing FT-600
FlipTop assembly, follow sections
and Secure the FlipTop Assembly.
Cut the Mounting Hole
A saw and the included cutout template are required to cut the
mounting hole.
1. Check the table surface and the area beneath the table. Clear any
obstructions that may impede the installation or functionality of the
FT2 assembly, retractors, and accessories.
2. Using the included cutout template, trace an outline of the mounting
hole onto the table.
3. Cut the mounting hole in the table with an appropriate saw.
Replace the FT-600 FlipTop Assembly
The FT-600 FlipTop assembly mounting hole is larger than the mounting
hole required for the FT2 assembly.
(sold separately) are used to help fill the gap between the mounting hole
and the FT2 assembly.
and FT2A-CBLR-GR series
Cut the Mounting Hole and
Replace the FT-600 FlipTop Assembly
FT2A-SPCR-MNT-10 plastic spacers
1. Loosen the four socket screws that secure the two mounting plates
and the FT-600 FlipTop assembly to the surface.
2. Remove the FT-600 FlipTop assembly.
3. Attach the four plastic spacers to each corner of the
FT2-700-ELEC-PTL.
Secure
4. Continue to prepare the FT2-700-ELEC-PTL by attaching the DC
power splitter cable. Refer to
Quick Start
Secure the FlipTop Assembly.
2