Related Manuals for Ninglu IM330
Summary of Contents for Ninglu IM330
- Page 1 Electronic Inclinometer Operation Manual Model：IM330 Document: NLT-IM330-SSEN Edition: V170525...
-
Page 2: Table Of Contents
Forward ................8 History Display ..............8 Backward ................9 Record Switch ..............9 Knob ................. 9 Sentence ................10 Connection ................13 Wiring diagram of IM330 back cover ........13 System internal wiring diagram ..........14 Installation and Calibration ............ 15... -
Page 3: Introduction
Introduction Introduction Electronic inclinometer IM330 is a device to measure ship hull posture, including roll actual angle, roll period, roll amplitude, pitch actual angle, pitch period, pitch amplitude, date, time, longitude and latitude, and to send them to VDR. It also has alarm function for ship’s officers... -
Page 4: Introduction
In the meanwhile, the messages of date, time, longitude and latitude are from GPS. And IM330 sends the roll angle and pitch angle to VDR, ECS and so on. -
Page 5: Technical Requirements
Technical Requirements Basic Parameters Dimension H264 x W270 x D93 mm 10.4 inch TFT color LCD, 640X480 pixels Two channels, DC 18.0V～31.2V，(24V, -25%～+30%) Power Supply AC 220/110V （50/60Hz） ， with AC adapter Alarm Type Roll Alarm, Pitch Alarm and Power Failure Alarm Alarm Flashing and Buzzer (press any key to cancel alarm) History Storage... -
Page 6: Operation
Operation Operation panel (9) (10) (11) (12) (13) (1) Alarm (2) Roll Mode (3) Roll-Pitch Mode (4) Pitch Mode (5) Zoom (6) Power (7) Day / Night (8) Language (9) Forward (10) History Display (11) Backward (12) Record Switch (13) Knob... - Page 7 Operation Alarm In the roll/pitch mode, press key [A], the words on the bottom left of screen ‘Roll Mode’/’Pitch Mode’ change to yellow colors, and adjust the knob to set the alarm value. Then press the key [A] again and the words ‘Roll Mode’/’Pitch Mode’...
- Page 8 Operation Roll-Pitch Mode Press the key [R-P] to enter roll-pitch mode. On the screen, it shows roll mode (amplitude, actual angle, period and alarm setting value), pitch mode (amplitude, actual angle, period and alarm setting value), date, time, longitude and latitude. Pitch Mode Press the key [P] to enter pitch mode.
-
Page 9: Pitch Mode
Operation Zoom In the roll/ pitch mode, press the key [Z] to zoom in or out the scale of the analog angle display. The angle range in the analog display is 0° ~90° (1° ), 0° ~45° (0.5° ), 0° ~18° (0.2° ) and 0° ~9° (0.1° ). Power Turn on or turn off the power supply. -
Page 10: Backward
Operation Backward Page backward the history record in History Display. Record Switch Turn on or off the history record to select if recording navigation messages. When the Record Switch is on, the words “Recording” will be shown on the bottom left of the screen. Then the main unit will record the messages, only when the actual angle is larger than the value of the alarm. -
Page 11: Sentence
Sentence Output sentence $--HRM,x.x,x.x,x.x,x.x,A,x.x,x.x,hhmmss.ss,xx,xx,xxxx,x.x,a *hh<CR><LF> Actual roll angle, degrees Roll period, seconds Roll amplitude, degrees This shall be a null field A - Status, A=data valid, V=data invalid This shall be a null field This shall be a null field This shall be a null field This shall be a null field This shall be a null field... - Page 12 Sentence Output sentence $--HPM,x.x,x.x,x.x,x.x,A,x.x,x.x,hhmmss.ss,xx,xx,xxxx,x.x, a*hh<CR><LF> Actual pitch angle, degrees Pitch period, seconds Pitch amplitude, degrees x.x - This shall be a null field A - Status, A=data valid, V=data invalid This shall be a null field This shall be a null field This shall be a null field This shall be a null field This shall be a null field...
- Page 13 Sentence Input sentence GPS data input $--RMC,hhmmss.ss,A,llll.ll,a,yyyyy.yy,a,x.x,x.x,xxxxxx,x.x,a*hh 10 11 12 UTC of position fix Status, A=data valid, V=navigation receiver warning Latitude Latitude, N/S Longitude Longitude, E/W Speed over ground, knots Course over ground, degree true UTC date， dd/mm/yy (10) Magnetic variation, degree, E/W (11) Mode indicator, A=Autonomous mode...
-
Page 14: Connection
Connection Wiring diagram of IM330 back cover... -
Page 15: System Internal Wiring Diagram
Connection System internal wiring diagram IM330 NMEA_A NMEA_A MAIN UNIT NMEA_B NMEA_B INPUT LIGHT NC BRIGHTNESS OFF LIGHT COM BRIGHTNESS COM LIGHT NO BRIGHTNESS ON IM330 ALARM LIGHT NC SOUND OFF MAIN UNIT LIGHT COM SOUND COM LIGHT NO SOUND ON... -
Page 16: Installation And Calibration
Installation and Calibration There are three methods to mount the main unit. Table, Hang and flash mounting is shown as follows. Use three screws for Table mounting Reassemble the rear cabinet upside-down when Hang mounting. Cut a chamfer angle square window on the working panel when Flash mounting. - Page 17 Hang Flush...
- Page 18 Installation and Calibration Power adapter mounting Power adapter（GA-240150），AC220/110V to DC24V，adapter holder and screws. Weight：0.24kg. Unit：mm...
- Page 19 Installation and Calibration The inclination sensor should be mounted towards the ship head and in a horizontal direction perpendicular to the mast. When calibration, the ship should be static and horizontal as much as possible. After finishing the installation, press “ ”...
Need help?
Do you have a question about the IM330 and is the answer not in the manual?
Questions and answers