KUKEN EASYCLEAN 6000 Instructions Manual page 28

Cleaning / Replacement
Part
Clean water tank
Dirty water tank
HEPA
Filter
Strainer
Brush coverage
Infrared sensor
Roller brushes
Drying tray
Loading station
Scroll wheels
Note: The above frequency is just for your reference. Actual cleaning / replacement frequency will depend on use.
Problem solving
Problems
Not loading
The handle control does not work.
EasyClean does not work.
EN
Recommended cleaning / replacement frequency
Cleaning after each use.
Cleaning after each use.
Cleaning after each use. / Replacement every 3-6 months
Cleaning after each use.
Cleaning after each use.
Cleaning after each use.
Cleaning after each use.
Cleaning after each use. / Replacement every 3-6 months.
Cleaning after each use.
Cleaning after each use.
Cleaning after each use.
Possible reasons
• The power supply does not
connect well.
• EasyClean does not connect well
with the charging station.
• The battery capacity is low.
• The handle does not connect well.
• The dirty water tank is full.
• The dirty water tank is not installed.
• The rotating brush is not installed.
28
Solutions
• Check the connection of the power
supply.
• Put the EasyClean back in the charging
station.
• Check the battery capacity and charge
it fully.
• Reinstall the handle.
• Empty the dirty water tank.
• Check and install the dirty water tank.
• Check and install the roller brush.