KUKEN EASYCLEAN 6000 Instructions Manual page 26

FILLING THE CLEANING TANK
1.Check the handle, clean water tank, dirty water tank, lithium-ion battery pack, rotating brush, make sure they are all installed
correctly and firmly.
2. Press the switch button on the handle to turn on EasyClean. Press the maximum mode button to change the suction power (figure
10).
Tips:
• DO NOT use EasyClean in large carpeted areas.
• DO NOT use EasyClean on delicate carpets, silk or similar floors.
• DO NOT SPRAY on carpets.
3. Press and hold the spray button for 8 seconds to prime the water or cleaning solution before each use. Spray the water according
to your personal use during cleaning.
4. Hold the handle and pull the EasyClean back and forth to clean the floor.
5. The tilt angle range of the handle should be within 60.5 degrees (up and down), please do not shake during use (figure 11).
6. Clean the dirty water tank after each cleaning use
Tips:
• DO NOT go over the edges of rugs.
• The UV lamp will work automatically. The UV lamp will stop working when you turn off the EasyClean or detect that the
brush set is off. Please DO NOT expose people or animals to the UV lamp in case of any UV radiation.
• The dirty water tank should be cleaned as soon as the cleaning job is finished.
• DO NOT turn the main body over before cleaning the dirty water tank or the water will flow into the vacuum motor and
damage the EasyClean.
10
EN
11
26