KUKEN EASYCLEAN 6000 Instructions Manual page 25

FILLING THE CLEANING TANK
1. The cleaning water tank is located at the rear of the main body, use your fingers to grasp the top of the water tank and pull it up to
remove it (figure 6).
2. Unscrew the water cap counterclockwise as shown below and add a little water, then screw and insert the clean water tank into
the EasyClean (figure 7).
• Do not screw the cap on too tightly or loosely as it may break or break the water tank.
• Users can also add some non-corrosive and non-flammable cleaning solutions, DO NOT add dirty water to the clean water tank.
• It is normal if there is some water in the tank on the first use, tests and inspections are done before the goods leave the factory
FILLING THE CLEANING TANK
1. Insert the drying tray into the loading station as shown in figure 8.
2. Place the charging station against the wall at your convenience, plug the power into the adapter plug of the charging station, then
plug the adapter into the power outlet.
3. Loading (figure 9):
TO). Place the EasyClean on the charging station and connect the adapter, then start charging.
B). Remove the lithium ion battery pack from the main body and charge it directly.
Tip: Charge EaseyClean for 12 hours the first time.
6
8
EN
7
9
25