Info Information marked with this symbol helps you to carry out your tasks quickly and safely. Follow the manual Information marked with this symbol indicates that the operating manual must be observed. radiant heater IR 2000 C / IRS 2010...
Page 3
• Insert the mains plug into a properly fused mains socket. • Observe the device's power input, cable length and intended use when selecting extensions to the power cable. Completely unroll extension cables. Avoid electrical overload. radiant heater IR 2000 C / IRS 2010...
Page 4
Do not stay in the device's immediate vicinity for too long. Do not look directly into the device for too long. Observe the minimum distances. Warning In order to avoid overheating and fire hazards, the device must not be covered! radiant heater IR 2000 C / IRS 2010...
• 2 heating levels of its vertical position. The device can again be used as usual • no dust circulation only a few seconds after placing it back in vertical position and on solid ground. radiant heater IR 2000 C / IRS 2010...
• with a cover to protect it from invasive dust, if necessary • Place no further devices or objects on top of the device to prevent it from being damaged. • Remove batteries from the remote control. radiant heater IR 2000 C / IRS 2010...
The device must not be placed directly below a socket, as the electrical cables may be hit when the device is being mounted. This may cause an electric shock. Observe the minimum distances for mounting the device (see chapter Technical data). radiant heater IR 2000 C / IRS 2010...
Page 8
ð Fix the plug of the power cable. 6. Adjust the radiant heater to the desired height and fix the telescopic rod with twist lock (5). 7. Carefully tilt the device. radiant heater IR 2000 C / IRS 2010...
Page 9
• Do not position the device IR 2010 directly below a wall socket. • Set the device IRS 2010 up in an upright and stable position. 4. Check the foot for tight fit. radiant heater IR 2000 C / IRS 2010...
Heating level 1 button Activate heating power 1000 W (together with heating level 2 = 2000 W) LED button Switching the LED elements on or off Heating level 2 button Activate heating power 1000 W (together with heating level 1 = 2000 W) radiant heater IR 2000 C / IRS 2010...
• Hold onto the mains plug while pulling the power cable out of the mains socket. • Clean the device according to the Maintenance chapter. • Store the device according to the Transport and storage chapter. radiant heater IR 2000 C / IRS 2010...
• Check whether the unit is switched on. companies or by Trotec. • Check all LED elements for damages. Cleaning the device • The LED elements may be defective. Contact the Trotec customer service. Warning of electrical voltage Never immerse the device in water! Note Wait for at least 3 minutes after maintenance and...
Directive 2006/66/EC of the Remote control AAA/1.5V AAA/1.5V European Parliament and of the Council of 6 September 2006 batteries on batteries and accumulators. Please dispose of batteries and accumulators according to the relevant legal requirements. radiant heater IR 2000 C / IRS 2010...