Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec IR 2200
Summary of Contents for Trotec IR 2200
- Page 1 IR 2200 OPERATING MANUAL RADIANT HEATER...
-
Page 2: Table Of Contents
• Let the device dry out after a wet clean. Do not operate it operating manual must be observed. when wet. • Do not use the device with wet or damp hands. • Do not expose the device to directly squirting water. radiant heater IR 2200... - Page 3 • Do not use the device if it has been dropped or if it shows visible signs of damage. radiant heater IR 2200...
-
Page 4: Information About The Device
Do not stay in the device's immediate vicinity for too long. Do not look directly into the device for too long. Observe the minimum distances. Warning In order to avoid overheating and fire hazards, the device must not be covered! radiant heater IR 2200... -
Page 5: Transport And Storage
• Place no further devices or objects on top of the device to prevent it from being damaged. Designation • Remove batteries from the remote control. Control panel Heating rod Grille Hole for ceiling holder Bracket for wall mounting Mains switch Remote control radiant heater IR 2200... -
Page 6: Assembly And Start-Up
Risk of fire due to improper installation! There is a risk of fire if the required minimum distances are not observed. Observe the “Installation” section in the “Assembly and start-up” chapter and the technical data in the “Technical annex” chapter. radiant heater IR 2200... - Page 7 • Please note that the minimum distance to the front also applies to objects mounted on the ceiling, e.g. fans, lamps or sprinkler systems. 2. Drill the drill holes into the wall at the marked positions. radiant heater IR 2200...
- Page 8 • Make sure that extension cables are completely unrolled. both Allen screws (12) again. • Make sure that there are no curtains or similar objects in the immediate vicinity. Prior to initial start-up, insert batteries in the remote control. radiant heater IR 2200...
-
Page 9: Operation
• Hold onto the mains plug while pulling the power cable out of the mains socket. • Clean the device according to the Maintenance chapter. • Store the device according to the Transport and storage chapter. Designation On/off switch Operating control lamp Remote control receiver radiant heater IR 2200... -
Page 10: Errors And Faults
• Wait for 10 minutes before restarting the device. If the device is not starting, have the electrics checked by a specialist company or by Trotec. The device does not emit heat: • The heating element may be defective. If the heating element is defective, have it replaced by a specialist electrical company. -
Page 11: Maintenance
Do not use any aggressive cleaning agents such as cleaning sprays, solvents, alcohol-based or abrasive cleaners to dampen the cloth. Wipe the housing dry after cleaning. Dirt on the heating rods should be removed with a long brush with soft bristles. radiant heater IR 2200... -
Page 12: Disposal
You can also find out about other return options that apply for many EU countries on the website https:// hub.trotec.com/?id=45090. Otherwise, please contact an official recycling centre for electronic and electrical equipment authorised for your country. - Page 13 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...