Buffer Memo; Disqualifying; Focus - ALGE-Timing Timy Manual

2.6

Buffer Memo

Mostly used if many competitors reach the finish at the same time and if there is not enough
time to indicate every single start number. The incoming times will be listed sequentially,
afterwards you can add the appropriate start numbers.
By pushing the button
be marked with a litte "m". The start number of the second line blinks. Enter the right start
number and confirm it with one of the "OK"-buttons.
If several competitor reached the finish at the same time (ex equo), then please act as
follows:
Indicate one of the right start numbers at the blinking one and press button
(Copy).
The time will maintain in the Memo window and you can add the next start number.
At the last competitor who will get the last time, press instead of "Copy" the "OK"-
button, so the time will be cleard of the Memo window.
If one time is still left which will not be required, you can clear it with button
You can leave the Memo window at any time and handle the left times at a later point.

2.6.1 Disqualifying

Press button
Add start number of the start number of the competitor who shall be disqualified
Confirm with button
Competitor will be cleared in the times list (3) and marked on the printout.

2.6.2 Focus

Press button . Now you can see in the top line of the times list always the last stopped
time. Please notice that thus the times list will be removed.
By pressing one if the button
Stopwatch
you will enter and leave the Memo mode. The Memo times will
or with one of the „OK"-buttons or cancel with button
you will inactivate the focus function.
.
.
Page 5