Dab Radio - JVC RA-E981B Instruction Manual

DAB+ RADIO
DAB mode receives DAB/DAB+ digital radio and displays information about the station, stream
and track playing.
Scanning for stations
The first time you select DAB radio mode, or if the station list is empty, the radio automatically
performs a full scan to see what stations are available.
To start a full scan choose "Scan" in the menu.
To start a manual tune choose "Manual tune" and the desired frequency.
Station selection
Press repeatedly /TUNING+ or
station from the list. Confirm the selection by pressing the OK knob on the device or OK on the
remote.
Settings menu
"Prune invalid" Once the scan is complete, the radio shows a list of available stations. To
remove all invalid stations (marked with "?") that are listed but not available choose this option.
"Dynamic range compression (DRC)" If you are listening to music with a high dynamic range
in a noisy environment, you may wish to compress the audio dynamic range. This makes quiet
sounds louder, and loud sounds quieter. You can change DRC as off, low or high.
"Station order" You can choose the order of the DAB station list to be either Alphanumeric,
Ensemble or Valid. Ensemble lists groups of stations that are broadcast together on the same
ensemble. Valid lists valid stations first, alphanumerically, then off-air stations.
FM RADIO
FM radio mode receives analogue radio from the FM band and displays RDS (Radio Data
System) information about the station and where broadcast.
Scanning for stations
To find a station, press OK. The frequency display starts to run up as the device scans the FM
band. Press the and hold
control to tune next/previous FM radio station that has a strong signal. Briefly press the same
buttons on the device or
Settings menu
"Scan settings" By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only at
stations with good signal strength, select "YES" after choosing "Strong station only?".
"Audio settings" All stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select "YES" after
choosing "Listen in mono only?".
BLUETOOTH
In Bluetooth mode, you can turn on the Bluetooth of your Bluetooth device. Go to the menu
and turn Bluetooth discoverable. From your Bluetooth device, search the radio JVC RA-E981B
to pairing. When it is waiting for pairing, there is a blinking Bluetooth icon at the bottom. If the
pairing is successful, the Bluetooth icon becomes steady. Control the music playback from your
Bluetooth device.
Control the music playback from your Bluetooth device. Press
back the forward track or go to the next track. Press
To disconnect from the radio, press and hold FAV/BT PAIR on the device or BT PAIR on the
remote control.
/TUNING- on the device or
/TUNING+ or /TUNING- on the device or
/ on the remote to find desired station/frequency.
EN
/ on the remote to select a
/
/ on the remote control to go
to play or pause the track.
on the remote