Cea Specifications - Orion XTR Power Amplifier XTR10001 Owner's Manual

1. +BAT
- connect this terminal through a FUse or CIRCUIt BReAKeR
to the positive terminal of the vehicle battery or the positive ter-
minal of an isolated audio system battery .
WARNING: Always protect this power wire by installing a fuse or
circuit breaker of the appropriate size within 12 inches of the battery
terminal connection .
2 . REM - this terminal turns on the amplifier when (+) 12 volt is
applied . Connect it to the remote turn on lead of the head unit
or signal source . If a (+) 12 volt remote turn lead is not available,
a Remote Power Adapter (P/n #oRRPA) can be used to supply a
remote turn on signal . Do not connect this terminal to constant
(+) 12 volt .
3. GND - power return connection . Connect this terminal directly
to the sheet metal chassis of the vehicle, using the shortest wire
necessary to make this connection . Always use wire of the same
gauge or larger than the (+) 12 volt power wire . the chassis con-
nection point should be scraped free of paint and dirt . Use only
quality crimped and/or soldered connectors at both ends of this
wire . Do not connect this terminal directly to the vehicle battery
ground terminal or any other factory ground points .
© 2008 Directed Electronics. All rights reserved.

CeA sPeCIFICAtIons

XtR5001
Power output: 150 Watts RMs x 1 at 4 ohms and
< 1% tHD+n
signal to noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 600 Watts RMs x 1 at 1 ohm
and < 1% tHD+n
XtR10001
Power output: 300 Watts RMs x 1 at 4 ohms and
< 1% tHD+n
signal to noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1200 Watts RMs x 1 at 1 ohm
and < 1% tHD+n
XtR15001
Power output: 400 Watts RMs x 1 at 4 ohms and
< 1% tHD+n
signal to noise Ratio: >70 dBA (reference 1 Watt
into 4 ohms)
Additional Power: 1600 Watts RMs x 1 at 1 ohm
and < 1% tHD+n
4