Table of Contents
Advertisement
APPENDIX
Symptom
Images are not displayed.
All buttons and switches
are disabled.
Monitor screen is off.
Cannot transfer files over a
USB connection.
Possible Cause
A memory card with non-DCF images recorded
with another camera is loaded in the camera.
Circuit problem caused by electrostatic charge,
impact, etc. while the camera was connected to
another device.
1) USB communication is in progress.
2) The monitor screen is turned off (in the REC
mode).
1) Camera is not set securely on the USB cradle.
2) USB cable is not connected securely.
3) USB driver is not installed.
4) Camera is turned off.
This camera cannot display non-DCF images
recorded onto a memory card using another digital
camera.
Remove the battery from the camera, reinsert it,
and then try again.
1) After the computer stops accessing camera file
memory, press the [USB] button on the USB
cradle. Check to make sure that the [USB] lamp
on the USB cradle is off, and then remove the
camera from the USB cradle.
2) Press [DISP] to turn on the monitor screen.
1) Check the connection between the camera and
USB cradle.
2) Check all connections.
3) Install the USB driver on your computer (page
140).
4) Press the [USB] button on the USB cradle.
168
Action
Advertisement
Table of Contents
