Recording Audio And Video From Separate Sources (Tx-8522 Only) - Onkyo TX-8522 Instruction Manual

TX- 85228222_En.book 25 ページ ２００６年５月４日 木曜日 午前１１時５１分
Recording —Continued
The signal flow in monitoring the recorded sound
TX-8522/TX-8222
T2 MONITOR OFF
TAPE 2
button
T2 MONITOR ON
Amplifier
PLAY
TAPE 2
The signal flow in monitoring the sound before
recording
TX-8522/TX-8222
T2 MONITOR OFF
TAPE 2
button
Amplifier
PLAY
You can overdub audio onto your video recordings by
simultaneously recording audio and video from two
separate sources. This is possible because only the audio
source is switched when an audio-only input source,
such as TAPE, FM/AM, or CD, is selected, the video
source remains the same.
Input source
In the following example, audio from the CD player
(CD, FM, etc.)
REC
connected to the CD IN jacks, and video from the
camcorder connected to the DVD IN VIDEO jack are
recorded by the VCR connected to the VIDEO OUT
jacks.
Input source
(CD, FM, etc.)
REC
Recording Audio and Video from
Separate Sources (TX-8522 only)
video signal
audio signal
CD player
1 Prepare the camcorder and CD player
for playback.
2
Prepare the VCR for recording.
3
Press the [DVD] input selector button.
4 Press the [CD] input selector button.
This selects the CD player as the audio source,
but leaves the camcorder as the video source.
5
Start recording on the VCR, then start
playback on the camcorder and CD
player.
Video from the camcorder and audio from the
CD player are recorded by the VCR.
Camcorder
VCR
25