Configuring The Speaker Impedance (Tx-8522 North American Model Only) - Onkyo TX-8522 Instruction Manual

TX- 85228222_En.book 13 ページ ２００６年５月４日 木曜日 午前１１時５１分
Connecting Your Speakers —Continued
Configuring the Speaker Impedance (TX-8522 North American model only)
In this model, the factory default for speaker impedance is "8 ohms." When you change the speaker impedance setting,
read "Speaker Connection Precautions" on page 12 carefully before performing the procedures below.
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
1
3
1
Turn on the power.
2
Press the SETUP button on the
remote controller.
The "Impedance: 8 ohms" indication
appears in the display.
3
Change the impedance value to
"6 ohms" using the [
buttons.
4
2, 4
SETUP
]/[ ]
Press the SETUP button on the
remote controller to complete the
setting.
When you restore the impedance
setting to 8 ohms, use the same
procedures above.
13