Care And Cleaning; Specifications; Troubleshooting - Pelonis HO-0280 User Manual

CARE AND CLEANING

1. Always remove the plug from the power socket and allow heater to cool. Wipe
heater with a soft, damp cloth. Do not use detergents and abrasives.
2. If the heater is not in use over a certain length of time, wind the cable around the
holder and store it in a dry place.
3. In case of malfunction, do not try to repair the heater by yourself. It may result in
fire hazard or electric shock.

SPECIFICATIONS

Voltage
120 V AC
This heater is designed for finite space heating or as a supplementary heating source.
It can not replace the main heat source during the winter.

TROUBLESHOOTING

Problem
Your heater shuts off
unexpectedly or fails to operate.
The room is not hot enough.
Please do not attempt to open or repair the heater by yourself.
Doing so may void the warranty and could cause damage or personal
injury.
Frequency Wattage
60 Hz 1500 W
Reason
1. There is no power.
2. The set temperature is lower than
the current room temperature.
3. The room temperature has reached
the temperature set at the thermostat.
4. One of the safety protection devices
had been activated to prevent
overheating.
1. The room is too large.
2. The window is open.
3. The set temperature is too low.
4. The power setting is too low.
6
Max. Current BTU Output
12.5 A 5120
Solution
Be sure it is plugged in and that the electrical outlet is working.
Set the desired temperature higher than the current temperature to
restart the heater.
1. This is normal. The heater will restart once room
temperature is lower than set temperature.
2. Adjust the thermostat setting if it's not set to your desired
temperature.
1. Place the heater in upright position.
2. Check for any obstructions. If you find an obstruction, turn the
heater off.
3. Unplug the heater and wait at least 10 minutes for it to cool down.
4. Carefully remove the obstruction. Plug the heater in and restart it
as described in the OPERATION section.
5. If you still notice the same problem, remove the plug from the
outlet and have the appliance checked by an authorized service
person.
1. Turn on the main heat source of the room.
2. Use more portable heaters.
3. Close the window.
4. Increase the temperature setting.
5. Select the higher power setting.