Advertisement
This heater includes a thermal cut-off that shuts the heater off if it
overheats due to abnormal conditions. If this occurs, turn the heater "OFF", unplug
it, and inspect and remove any objects on or adjacent to the heater. Allow it to
cool for a few minutes, and then plug it back in and resume normal operation.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
Ensure that your circuit breaker or fuse is working properly.
•
Be sure the heater is plugged in and that the electrical outlet is working properly.
•
Check for any obstruction. If you find an obstruction, turn the heater "OFF." Unplug
•
the heater and wait a few minutes for it to cool down. Carefully remove the
obstruction. Plug the heater in and turn it on again by referring to the OPERATING
INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY
INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE
HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR
PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO
THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in
order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF
AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-season storage
Turn the heater "OFF," unplug it and wait for the heater to cool down.
•
Use a dry cloth to clean only external surfaces of the heater.
•
Do not use any cleaning agents or detergents.
•
Never immerse the heater in water.
•
Pack the heater in the original carton and store it in a cool and dry place.
•
SPECIFICATIONS
Model No.: PTH15A2BGB
Voltage: 120V~, 60Hz
Current: Maximum continuous draw: 12.5 Amps
Output: 5200 BTUs
Power: LOW=900 Watts, HIGH=1500 Watts
Tolerances on all specifications:Approximately +5%
3
Advertisement
