Assembly Instruction
Check where and what height you'd like to assemble on the wall, put the fixing frame (19) on the wall
l
and mark the four location holes by pencil. Remove (19) and then drill the four holes on the wall whose
dia. is about 15 mm and depth is about 110 mm. Put the 4 expanding tubes of expanding bolt sets (18)
into the four holes.
The recommended height of the basket is from 2.1 to 3.05 m (3.05 m is the official height of
l
the basket). If you want to have this height, attach low screw in a height of 250 cm from
the ground.
How to attach the rim (2) to the backboard (1), first split the longer spring bolt set (4) into screw,
l
washer and nut. Split the shorter spring bolt set (5) into screw, washer and nut. Using the 2 longer
screw of (4) go through the top 2 holes of rim(2) and backboard(1), tighten with washer of 4 and nut of
4. Using the 2 shorter screw of (5) go through the bottom 2 holes of rim (2) and backboard (1), tighten
with washer of (5) and nut of (5).
How to attach a bottom brace(10) to the back of the backboard(1).Using M10X40 hexagon screw (8) and
l
dia. 10mm flat washer (9) to go through the hole of a bottom brace(9) and the back of the backboard
Part list
18
EN