Charge & Sync; Auto-Detect Charging; Input Detection - VeriFone e285 Installation Manual

Charge & Sync
Auto-detect
Charging
NOTE

Input Detection

6
e285 Power Bank LED state while connected to wall charger:
•
1st LED blinking represents the power bank is in charging mode and the
battery is between 1% to 24%. Once the 1st LED is solid, then the power
bank is 25% charged.
•
2nd LED blinking represents the power bank is in charging mode and the
battery is between 26% to 49%. Once the 2nd LED is solid, then the power
bank is 50% charged.
•
3rd LED blinking represents the power bank is in charging mode and the
battery is between 51% to 74%. Once the 3rd LED is solid, then the power
bank is 75% charged.
•
4th LED blinking represents the power bank is in charging mode and the
battery is between 76% to 99%. Once the 4th LED is solid, then the power
bank is 100% charged.
7
If the e285 Power Bank does not charge within 12 hours, then the power bank
will enter protection mode and stop receiving power from the wall charger.
When this protection mode is active the 4 LEDs on the back of the power bank
will flash (0.5 sec "ON" & 0.5 sec "OFF") continuously to inform user.
8
To exit this protection mode, the e285 Power Bank needs to be disconnected
from the wall charger and then re-connected. If the e285 power bank still
cannot be charged in 12 hours, then it will re-enter the protection mode.
9
30 minutes timeout after the e285 goes to sleep. Press the button to wake the
power bank back up once the e285 is awake.
Connect the case to power using any USB-C charger to allow pass-through
charge & sync; the device charges first, and then the juice pack's internal battery.
a
Auto detect capability is required at the output connector (USB-C Plug)
b
Auto detect is required when the input (either when the wall adapter or
Multi-Charger) is attached to the juice pack.
1
Wall Adapter can be connected to the USB-C receptacle connector of the
juice pack.
2
Multi-Charger can be connected to the Charging Pads of the juice pack.
1
Power bank will be able to charge from:
a
Any 5W, 10W, 12W
b
Any 18W, 20W, 29W (if possible Apple), 30W, 61W, 87W, 96W
c
PC/ Mac 5W~7.5W
d
BC1.2 chargers defined in the USB BC1.2 specification
2
Will not take power from any smart device (e.g., a smartphone)
3
Default to 2.5W (if cannot identify the power source) per USB-IF requirement.
285 P
E OWER
285 P B I
E OWER ANK NSTALLATION
B S
ANK ETUP
Charge & Sync
13
G
UIDE