3. Press the item to set measurement parameters, press the
button Next to establish through the following 3 ways;
CoeK Input equation coefficients K.
StdI
Input the standard samples concentration and
absorbance.
StdM
Guide the measurement of standard samples
absorbance and input concentration according to
the program.
4. Press the button Measure to start after the establishment
is completed;
5. Put the reference in the measurement channel, press the
icon
to do zero.
6. Put the sample in the measurement channel, press the
icon
to measure a sample and record the result.
7. Press the icon
to browse the result(s).
Spectrum scan
1. Main interface, press the icon
to start a Spectrum
application;
2. Press the icon
to setup the measurement parameters;
3. Press the item to select or key in the parameters, press the
button Measure to accept the new parameters and back
to measurement interface;
4. Put the reference in the measurement channel, press the
icon
to scan baseline;
5. Put the sample in the measurement channel, press the
icon
to scan sample and record the results;
6. Press the icon
the curve and results.
For more details, please
consult the full manual.
Europe
VWR International bv
Researchpark Haasrode 2020
Geldenaaksebaan 464
B-3001 Leuven
+ 32 16 385011
http://be.vwr.com
UK Importer
VWR International Ltd
Hunter Boulevard, Magna Park
Lutterworth, Leicestershire, LE17 4XN
http://uk.vwr.com
Made in China
QUICK MANUAL
VWR
®
M4/PV4/P4
UV/VIS Spectrophotometer
EU Catalogue Number
M4 : 634-1087
PV4 : 634-1088
P4 : 634-1089
Safety Information
Avoiding Electrical Shock
Please follow the guidelines below, and read this manual
in its entirety to ensure safe operation of the unit.
VWR recommends against the use of M4, PV4 and P4
UV/VIS Spectrophotometer.
To avoid electrical shock
• Do not open the device.
• Disconnect the device from the mains supply before
carrying out maintenance work or changing the fuses.
• The inside of the device is a high-voltage area Danger!
• Do not use the device if it is damaged, especially if the
main power cable way is in any damaged or defective.
• Repairs may only be carried out by the service
technicians from your local VWR office and authorized
contractual partners.
• The device must be connected to a power outlet that
has a protective ground connection.
• If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
equipment may be impaired.
Avoiding Damage to the Instrument
• Do not allow any liquid to enter into the device.
• Do not operate the device in a hazardous location
or potentially explosive environment.