ADJ FOG FURY JETT PRO User Manual page 8

1. Open the shipping carton and carefully remove the unit from the shipping carton.
2. Be sure to remove all the packing material, paying special attention to the area around the nozzle.
3. Set the fog machine on a flat dry surface and fill the fog fluid reservoir with ADJ brand fog juice.
Place the feeder tube with the filler deep inside the reservoir and tighten the cap.
4. Firmly attach the remote control receiver to the rear remote control socket on the unit.
5. Plug the unit in to a matching power supply. At this time, the red LED located on the remote
receiver will glow red, indicating that the unit is heating up. The device requires approximately
nine minutes to reach normal operating temperature. When it has reached operating temperature,
the green LED on the remote receiver will glow.
6. Emit fog using either the button on the remote, or the manual button on the rear of the unit.
7. Follow the operating instructions on the next few pages for proper operation.
NOTE: If the LED under the reservoir begins to flash, this indicates that fog juice fluid is low.
Always maintain an adequate supply of ADJ Brand Fog Juice in the fluid reservoir. Running
the fog machine dry will cause pump failure and/or clogging. This is the largest cause of fail-
ure in fog and haze machines. Only ADJ Fog Juice is recommended for use, and not all fog
juice is created equal.
SETUP
8