Replacement of plunger solenoid
1. Remove the side cover. (Refer to steps 1 to 3 in Section 1-6-1.)
2. Remove the lens assembly. (Refer to Section 1-6-2.)
3. Remove the rear cover assembly and lens cover assembly. (Refer to Section 1-6-3.)
4. Remove the top cover assembly. (Refer to steps 1 to 4 in Section 1-6-5.)
5. Remove the C board. (Refer to Section 1-6-6.)
6. Remove the air intake fan block. (Refer to steps 1 to 9 in Section 1-6-8.)
7. Loosen the four screws (with drop-safe).
8. Remove the two hooks, then remove the filter cover and electrostatic filter.
Two hooks
Electrostatic filter
Filter cover
Screws (with drop-safe)
1-34 (E)
VPL-FH60