Tools And Materials; Before You Begin - Kohler K-3447 Installation Manual

Tools and Materials

Supply
10" Adjustable
Shut-Off
Wrench
Valve
Tubing Cutter Wax Seal
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

CAUTION: Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.
IMPORTANT! Record the model number (from the label on the box)
in the Homeowners Guide for reference.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
If the existing toilet does not have a supply shut-off valve below
the tank, install one before installing the new toilet.
Provide an adequate amount of clearance for the toilet's lift rod.
Clearance values are measured from the floor to the top of the
fully extended rod.
• K-3456, K-3555 and K-14239 require 37-5/8" (95.6 cm) of
clearance.
• K-3463 requires 37-1/8" (94.3 cm) of clearance.
• K-3444, K-3461 and K-3464 require 35" (88.9 cm) of clearance.
• K-3447 requires 34-3/8" (87.3 cm) of clearance.
1021797-2-B
Tape
Sponge
Level
Measure
Plus:
• 5/16" T-Bolts w/ Nuts and Washers
• Putty Knife
• 1/2" Open-End Wrench
Safety
• 1/2" Nut Driver/Socket
Glasses
• Hacksaw
2
Pipe Wrench
Kohler Co.