Table of Contents
Advertisement
3
Installation > Installation Overview > The following shows "installation overview of Installation Procedure for iR-ADV Security Kit-B1 for IEEE 2600.1 Common Criteria Certification".
Installation Overview
The following shows "installation overview of Installation
Procedure for iR-ADV Security Kit-B1 for IEEE 2600.1
Common Criteria Certification".
Products required when installing iR-ADV Security Kit-B1 for IEEE 2600.1 Common Criteria
Certification
HDD Data Encryption & Mirroring Kit-C *1
Access Management System-B *1
Data Erase Kit-C *1
Canon imageRUNNER ADVANCE 4000 Series *2
*1 Check that VOID seals are affixed to HDD Data Encryption/Mirroring Kit-C, Access
Management System-B, and Data Erase Kit-C.
*2 Visually check the host machine hardware to ensure that there is no sign of falsification or
fraudulent switching of parts.
1. Installing the Hardware
Installing the Host Machine
(Refer to imageRUNNER ADVANCE 4051/4045/4035/4025 Series Service Manual:
Installation.)
Installing the Encryption/ Mirroring Board
(Refer to imageRUNNER ADVANCE 4051/4045/4035/4025 Series Service Manual:
Installation > Combination of HDD Options.)
3
Installation > Installation Overview > The following shows "installation overview of Installation Procedure for iR-ADV Security Kit-B1 for IEEE 2600.1 Common Criteria Certification".
2. Installing the System
1) Remove the VOID seal from the IEEE2600 certification kit, take out the CD-ROM and
register the firmware to SST.
2) Install the registered firmware after formatting according to the following Installation
Procedure.
HDD Data Encryption & Mirroring Kit-C Series HDD Data Encryption Kit-C Series
Installation Procedure (Refer to FT1-0323.)
3) Install the 2600 CC certification firmware.
3. License Certification
Enable all the following licenses.
Access Management System-B
Data Erase Kit-C
iR-ADV Security Kit-B1 for IEEE 2600.1 Common Criteria Certification
4. Change in Login Service
1) Using SMS, change the login service of the host machine to SSO-H.
Choose "Service Management Service" with a screen of "Remote UI : Portal".
Login in Service Management Service.
In System Management > Enhanced System Application Management > Login
Service,push the switch button of Single Sigen-On H.
2) After registration, restart the host machine to enable the setting.
5. IEEE2600 Unified Security Settings
Settings/Registration / Registration > Management Settings > Device Management
Settings > Unified Security Settings
3
3
Advertisement
Table of Contents
