Advertisement
GE
Lumination
Tetra
LED Systems Power Supply
®
(GEXLPS21 & GEXLPS21-U)
Power Supply Features
Power Supply Installation
Black (line)
White (neutral)
AC line
1
Connect the AC line to the
black (line) and white (neutral)
input wires of the power
supply using 18-14 AWG
2
(0.82-2.08 mm
) twist-on wire
connectors.
imagination at work
• Supports all colors of Tetra
Tetra
• Class 2 wiring per NEC Article 725 (SELV)
• Damp location rated
• IP66 rated: separate enclosure required
Input
wires
Load bank
Blue
Splice connector GECLSC2
2
Connect the supply wire that is
attached to the LED strip to the
power supply load bank using
the GECLSC2 splice connector.
®
®
Power White XL LED Lighting Systems
Red (+)
White (-)
Supply wire
to LED strip
Risk of electrical shock. Turn power OFF before inspection,
installation or removal.
Installation Guide
XL and
NOTE: Exceeding maximum
load will cause the power supply
to shut down. Once the excess
load is removed, cycle the input
power to restart the power
supply.
Specific load information for
the supported LED systems can
be found in the "Power Supply
Specifications" section on the
next page.
WARNING
12
Volt
Advertisement
Table of Contents
Related Manuals for GE Tetra GEXLPS21
Summary of Contents for GE Tetra GEXLPS21
- Page 1 Installation Guide Lumination Volt Tetra LED Systems Power Supply ® (GEXLPS21 & GEXLPS21-U) Power Supply Features ® • Supports all colors of Tetra XL and ® Tetra Power White XL LED Lighting Systems • Class 2 wiring per NEC Article 725 (SELV) •...
- Page 2 (1.888.694.3533) Lumination, LLC is a subsidiary of the General Electric Company. Tetra is a trademark of Lumination, LLC. The GE brand, logo, and ecomagination are trademarks of the General Electric Company. © 2008 Lumination, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Need help?
Do you have a question about the Tetra GEXLPS21 and is the answer not in the manual?
Questions and answers