Table of Contents
Advertisement
Icon
Description
Computer Export Icon: Indicates meter
is actively exporting measurement data
or calibration data to a computer.
Printer Export Icon: Indicates meter is
actively exporting measurement data or
calibration data to a printer.
2.5 Meter Connections
Input
Function
Power
Universal power supply
GND
Ground
Export
Connection to printer or computer
Conductivity Connection to conductivity electrode
10
Chapter 2 | Getting Started
2.6 Electrode Information
The accumet AB330 conductivity meter is compatible with
2-cell and 4-cell conductivity electrodes with a DIN
connector. The accumet AB330 conductivity meter can be
purchased in a meter only configuration (purchase
electrode separately) or kitted with a conductivity
electrode.
Refer to the electrode instructions for specific care and
maintenance procedures. The following are general
recommendations for electrode preparation.
Remove the packaging from the electrode and
save for storage.
Rinse the electrode using distilled water.
Connect the electrode to the meter.
2.7 Meter Startup
Sequence
When the meter is powered on, it displays a set of startup
screens, starting with all segments lit screen, followed by
the meter info screen and then the meter self-test screen.
The meter info screen shows the meter model number and
current software revision.
After the meter info screen, the meter performs a series of
internal self-tests to verify that the meter is operating
correctly and then the self-test results are shown.
Finally, the meter proceeds to the main measure mode.
Advertisement
Table of Contents
