Troubleshooting - BorMann Pro BBP4500 Manual

EN

Troubleshooting

Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool.
Instead, seek help in an Authorized Service Centers, always using apropriate replacement parts for repairs (Bormann replacement parts).
Malfunction status
The chain saw does not start
The saw chain does not run.
The motor stops running after a
little use.
No oil on the chain.
The chain saw does not reach
maximum RPM.
Chain does not stop even the if
chain brake is activated:
Stop the machine immediately!
Abnormal vibration:
Stop the machine immediately!
14
Cause
Two battery cartridges are not installed
Battery problem (low voltage).
Main power switch is off.
Chain brake activated.
Battery's charge level is low.
Oil tank is empty.
Oil guide groove is dirty.
Poor oil delivery
Battery cartridge is installed improperly.
Battery power is dropping.
The drive system does not work correctly.
Ask the authorized service center in your
The brake band is worn down.
Loose guide bar or saw chain.
Tool malfunction.
WWW.BORMANNTOOLS.COM
Install two charged battery cartridges.
Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
The chain saw is automatically turned off if it is unoperated for a certain
period. Turn on the main power switch again.
Release chain brake.
Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
Fill the oil tank.
Clean the groove.
Adjust the amount of oil delivery with the
adjusting screw.
Install the battery cartridges as described in this manual.
Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
Ask the authorized service center in your region for repair.
Ask the authorized service center in your region for repair.
Adjust the guide bar and saw chain tension.
Ask the authorized service center in your region for repair.
Action