Table of Contents
Advertisement
Available languages
Available languages
EN
4. Replacing the sprocket:
Before fitting a new saw chain, check the condition of the sprocket. Beware
that a worn sprocket will damage a new saw chain. Have the sprocket re-
placed in this case.
1. Sprocket 2. Areas to be worn out
6. Storing the tool:
a. Clean the tool before storing. Remove any chips and sawdust from the tool
after removing the sprocket cover.
b. After cleaning the tool, run it under no load to lubricate the saw chain
and guide bar.
Periodic Maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features, the following maintenance must be performed regularly. Warranty
claims can be recognized only if this work is performed regularly and properly. Failure to perform the prescribed maintenance work can lead to accidents! The
user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must be carried out by our author-
ized service center.
Check item
/ Operating time
Before operation
Inspection
Chain Saw
Cleaning
Inspection
Service Center
Saw chain
Inspection
Sharpening (if needed)
Guide bar
Inspection
Remove from chain saw
Chain brake
Check function
Regular inspection in
service center
Chain lubrication
Check the oil feed rate
Switch trigger
Inspection
Lock-off lever
Inspection
Oil tank cap
Check tightness
Screws and nuts
Inspection
13
5. Always fit a new locking ring when replacing the sprocket.
1. Locking ring 2. Sprocket
NOTICE: Make sure that the sprocket is installed as shown in the figure.
c. Cover the guide bar with the guide bar cover.
d. Empty the oil tank.
Before operation
Every day
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
WWW.BORMANNTOOLS.COM
Every week
Every 3 months
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Annually
Before storage
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Advertisement
Table of Contents
