Operation; Working With The Chainsaw - BorMann Pro BBP4500 Manual

EN

OPERATION

Lubrication
Saw chain is automatically lubricated when the tool is in operation. Check
the amount of remaining oil in the oil tank periodically through the trans-
parent oil tank window. To refill the tank, lay the chain saw on its side, pull
up the lever and turn anticlockwise to remove the oil tank cap. The
proper amount of oil is 160 ml. After refilling the tank, make sure that the
oil tank cap is tightened securely.
1. Lever 2. Oil tank cap 3. Oil tank window 4. Oil tank

Working with the chainsaw

i. The first time user should, as a minimum practice, do cutting logs on a
saw-horse or cradle.
ii. When sawing precut timber, use a safe support (saw horse or cradle).
Do not steady the workpiece with your foot, and do not allow anyone else
to hold or steady it.
iii. Secure round pieces against rotation.
iv. Keep all parts of the body away from the saw chain when the motor is
operating.
v. Hold the chain saw firmly with both hands when the motor is running.
vi. Do not overreach. Keep proper footing and balance at all times.
11
After refilling, hold the chain saw away from the tree. Start it and wait until
lubrication on saw chain is adequate.
NOTICE:
i. When filling the chain oil for the first time, or refilling the tank after it has
been completely emptied, add oil up to the bottom edge of the filler neck.
The oil delivery may otherwise be impaired.
ii. Use the saw chain oil exclusively for Liangye chain saws or equivalent oil
available in the market.
iii. Never use oil including dust and particles or volatile oil.
iv. When pruning trees, use botanical oil.
v. Mineral oil may harm trees.
vi. Before the cutting operation, make sure that the provided oil tank cap
is screwed in place.
NOTICE: Never toss or drop the tool. Do not cover the vents of the tool
Bring the bottom edge of the chain saw body into contact with the branch
to be cut before switching on. Otherwise it may cause the guide bar to
wobble, resulting in injury to operator. Saw the wood to be cut by just
moving it down by using the weight of the chain saw.
WWW.BORMANNTOOLS.COM