Download Print this page

Pro-Ject Audio Systems Box-Design MaiA S3 Instructions For Use Manual page 3

Advertisement

Phono input
Connect the tonearm signal lead to the In 1 (Phono) of the amplifier. The earthing wire may be connected to
the screw terminal if you encounter hum problems when using the turntable. The phono input is suitable for
MM and High-Output MC cartridges.
Line inputs
Line level sources (CD player, radio or TV) can be connected to the inputs marked In 2, In 3 or In 4.
Digital inputs
Sources with a digital output such as TV satellite/cable receiver or a game console can be connected to the
digital inputs. Coaxial to In 5 and optical to In 6 and In 7.
Mains power connection
Connect the low voltage plug from the power supply to the Power socket before connecting the power supply
to the mains.
Front panel controls
To switch on from standby or to standby
The push button on the left side of the front panel turns the unit on or back into standby. The blue LED above
the stand-by push button shows that the unit is switched on. Mute is active when LED is blinking.
Input selector
Pressing the buttons
and
selects the desired input. The LEDs show which input is currently active.
Volume
Adjust the volume to the desired level, using the large knob on the front panel.
Connecting a headphone
Connect the headphones to the ¼" (6,3mm ∅) jack socket on the front of the unit.
BT connection
Make sure the antenna is attached to its connector In 8 (BT) on the back panel prior using BT.
Only use the supplied antenna!
BT is active only when input 8 is selected. If you want to connect your device the first time activate the pairing
mode by pressing and hold the button
(pair) until LED 8 starts blinking. The MaiA is now visible & ready to
pair for 60 seconds.
3
© Pro-Ject Audio Systems · MaiA S3 · Revision 2022.01.03

Advertisement

loading

This manual is also suitable for:

Box design s3 bt