End Product User Manual Requirements; Anatel Brazil Compliance; Australia And New Zealand Regulatory Compliance - Ublox NINA-B3 Series System Integration Manual

Figure 28: Sample label of an end product that includes a NINA-B31 series module
5.5.3

End product user manual requirements

The KCC logo and NINA-B3 certification numbers described in the
requirements must also be included in the end products user manual.

5.6 Anatel Brazil compliance

When a product containing a NINA-B3 module is placed on the Brazilian market, the product must be
affixed with a label or marking containing the Anatel logo, NINA-B3 Homologation number:
03851-19-05903 and a statement claiming that the device may not cause harmful interference but
must accept it (Resolution No 506).
"Este equipamento opera em caráter secundário, isto é, não
tem direito a proteção contra interferência prejudicial, mesmo
de estações do mesmo tipo, e não pode causar interferência a
sistemas operando em caráter primário."
Statement translation:
"This equipment operates on a secondary basis and, consequently, must accept harmful interference,
including from stations of the same kind, and may not cause harmful interference to systems
operating on a primary basis."
When the device is so small or for such use that it is not practicable to place the statement above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the
Anatel logo, NINA-B3 Homologation number and/or this statement, the Anatel logo, NINA-B3
Homologation number and the statement shall also be included in the end-product manual.

5.7 Australia and New Zealand regulatory compliance

The NINA-B3 modules are compliant with AS/NZS 4268:2012/AMDT 1:2013 standard
– Radio equipment and systems – Short range devices – Limits and methods of
standard measurement made by the Australian Communications and Media Authority
(ACMA).
The NINA-B3 module test reports can be used as part of evidence in obtaining permission the
Regulatory Compliance Mark (RCM). To meet overall Australian and/or New Zealand compliance on
the end product, the integrator must create a compliance folder containing all the relevant
compliance test reports.
UBX-17056748 - R13
C1-Public
R-C-ULX-NINA-B31
03851-19-05903
Regulatory information and requirements
NINA-B3 series - System integration manual
KCC end-product labeling
Page 57 of 72