>10
Figure 13: Extend GND plane outside the NINA-B3x6 module
Figure 14: Size of the GND cut out for the NINA-B3x6 module
3.4 Supply interfaces
3.4.1
Module supply design
For correct RF performance, a good connection of the module VCC pin with DC supply source is
necessary. Guidelines for the supply design are summarized below:
•
The VCC connection must be as wide and short as possible.
•
The VCC connection must be routed through a PCB area separated from sensitive analog signals
and sensitive functional units. It is a good practice to interpose at least one layer of PCB ground
between the VCC track and other signal routing.
UBX-17056748 - R13
C1-Public
>10
8m
m
Design-in
NINA-B3 series - System integration manual
>10
3,1mm
Page 39 of 72