Table of Contents
Advertisement
5.2 FCC/ISED – US/Canadian markets
5.2.1
Compliance statements
The NINA-B3 series modules comply with Part 15 of the FCC Rules and with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that the
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to correct the interference using either one or more of the following
measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
⚠
Since u-blox cannot control how integrators of NINA-B30 will operate the module, an extra
precaution is required by the FCC/ISED. NINA-B30 customers are required to undergo a 'Change
in ID' process. See also
⚠
The NINA-B3 modules are for OEM integrations only. The end product has to be professionally
installed in such a manner that only the authorized antennas can be used. See also
selection.
⚠
Any changes to hardware, hosts or co-location configuration may require new radiated emission
and SAR evaluation and/or testing. Any changes or modifications NOT explicitly APPROVED by
u-blox may cause the NINA-B3 module to cease to comply with the FCC rules part 15 thus void the
user's authority to operate the equipment on the US market.
Model
NINA-B301
NINA-B302
NINA-B306
NINA-B311
NINA-B312
NINA-B316
Table 12: FCC IDs and ISED certification numbers for the NINA-B3 series modules
5.2.2
RF Exposure
NINA-B3 series modules comply with the FCC radiation exposure limits and the requirements of IC
RSS-102 issue 5 radiation exposure limits set forth for an uncontrolled environment.
UBX-17056748 - R13
C1-Public
Change in ID/Multiple Listing
FCC ID
XPYNINAB30
XPYNINAB30
XPYNINAB30
XPYNINAB31
XPYNINAB31
XPYNINAB31
Regulatory information and requirements
NINA-B3 series - System integration manual
process..
ISED certification number
8595A-NINAB30
8595A-NINAB30
8595A-N INAB30
8595A-NINAB31
8595A-NINAB31
8595A-NINAB31
Antenna
Page 49 of 72
Advertisement
Table of Contents
