Cleaning, Care And Maintenance - Buffalo FB862 Instruction Manual

Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning and
maintenance.
• Always keep the oven clean!
• Clean the door frame, seal and neighbouring parts carefully with a damp
cloth when dirty.
Cleaning the door and oven front face
• For best performance and to maintain the high degree of safety, the inner door panel and oven front
face should be free of food or grease build-up.
• Wipe these parts with a mild detergent, rinse and wipe dry. Never use abrasive powders or pads.
Cleaning the control panel and plastic parts
• Do not apply a detergent or an alkaline liquid spray to the control panel and plastic parts, as this may
cause damage to these parts.
• Use a dry cloth (not a soaked cloth) to clean these parts.
• Do not allow the control panel to become wet.
Cleaning the oven interior
• After use be sure to remove spilled liquids, spattered oil and food debris as quickly as possible.
• If the oven is used when dirty, efficiency drops and the dirt gets stuck on the oven surface. This may
cause bad odours.
• Clean the interior with a cloth soaked in luke-warm water with a mild detergent dissolved in it, then
rinse the soap off with a damp cloth.
Remove any odours in the oven interior by microwaving a cup of water with the
juice of 1 lemon for 5 minutes. Wipe the oven clean with a soft dry cloth.
Caution: Personal Injury Hazard!
It is hazardous for anyone other than a competent person to carry out any
service or repair operation that involves the removal of a cover which gives
protection against exposure to microwave energy.
Caution: Do Not wipe plastic and painted sections of the oven with bleach,
thinners or other cleaning agents, as this may cause these parts to dissolve or
distort.
FB862_ML_A5_v2_20220527.indb 15 FB862_ML_A5_v2_20220527.indb 15
EN
15
2022/5/27 10:21 2022/5/27 10:21