Switching On The Navigon 7310 - Navigon 7310 7310 User Manual

places. This enables the device to calculate a route between a starting
point and a destination.
Calculation of the current position and its representation on the map
take place approximately once every second. In other words, your
current position is always shown on the map.
3

Switching on the NAVIGON 7310

1. Press the
switches on. (Approx. 2 seconds)
If password protection has been activated, the E
window opens.
2. Enter the password.
3. Tap on OK.
The N
Note: When you switch on the NAVIGON 7310 for the first time, you
will be asked to make the following settings:
your preferred language for using for the software
►
the unit of length for distances
►
the time format
►
Note: If you have not used the NAVIGON 7310 for a long time, the
battery may be flat.
In this case the device must first be connected to the car charger cable
or to a suitable charger and be charged for approximately 3 minutes
before it can be switched on.
Charging takes a relatively long time when the navigation device is
activated. If you are not using the navigation device, switch it off or to
standby for charging purposes.
Chargers and other accessories are available in the NAVIGON online
shop at
Forgotten your password?
If you forget your password, follow the procedure described in
" F orgotten your password?" on page
2
Switching the navigation device to standby mode
Press briefly (max. 2 seconds) on the
►
- or -
Switching on the NAVIGON 7310
(On/Off) key and keep it pressed until the device
window opens.
AVIGATION
w ww.navigon.com
1
User's manual NAVIGON 7310
or in specialist stores.
1 8.
2
NTER PASSWORD
(On/Off) key.
- 15 -