Navigon 7310 7310 User Manual page 75

I have connected a charger to the NAVIGON 7310. A connection to a
computer is shown on the display.
- or -
I have connected the NAVIGON 7310 to a computer but it is not detected
as a removable disc.
The USB connector of the charger is not fully inserted in the case.
1. Unplug the connector.
The navigation device will carry out a new start. Wait for the
navigation software to be reloaded.
2. Without delay, insert the USB connector from the charger into the
corresponding socket of the NAVIGON 7310 as far as it will go.
(Refer to "
The USB connector is not connected correctly. See above.
My NAVIGON 7310 makes no response any longer, the screen is frozen.
Perform a reset. This can be done in two ways:
Use a thin object to press the Reset key. (Refer to "
►
the NAVIGON 7310" on page
- or -
1. Press the
The device is now deactivated.
2. Press the
switches on again. (Approx. 2 seconds)
The software will be restarted. Your settings and your saved
destinations and routes will be retained.
It seems to me that the battery of my NAVIGON 7310 becomes flat
relatively quickly when the device is not connected to an external power
supply.
Some settings can be configured so that energy consumption is
minimised.
1. in the N
2. Set the values for Brightness Day and Brightness Night as low as
possible.
3. Set Use Voice Control to Entering Addresses.
4. Tap on OK.
5. Tap on
6. Tap on Settings > Bluetooth Function.
Troubleshooting
D escription of the NAVIGON 7310" on page
4
(On/Off) switch for at least 6 seconds.
(On/Off) key and keep it pressed until the device
window tap on Options > Settings > General.
AVIGATION
(Phone).
User's manual NAVIGON 7310
8 .)
4
8 .)
4
D escription of
4
- 75 -