Table of Contents
Advertisement
3.) WARNING! Risk of electric shock. Connect only to a grounding type receptacle
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electri-
cian if you cannot verify that the receptacle is protected by a GFCI.
4.) Do not bury the cord. Locate the cord to minimize abuse from lawn mowers, hedge
trimmers, and other equipment.
5.) WARNING! To reduce the risk of electric shock, replace damaged cord imme-
diately.
6.) WARNING! To reduce the risk of electric shock, do not use an extension cord
to connect the unit to the electricity supply; provide a properly located outlet.
7.) Save these instructions!
1.5 Hazards due to non-compliance with safety instructions
Failure to comply with safety instructions may endanger not only people, but also the
environment and the dosing pump/system. Non-compliance with the safety instructions
can lead to the loss of all entitlement to damages.
The following hazard in particular may arise:
•
Danger to people due to electrical, mechanical and chemical effects.
•
Failure of system functions.
•
Danger to the environment due to leakage of hazardous substances.
1.6 Safe operation
The safety instructions in this Operation & Maintenance Manual must be observed.
The owner is responsible for ensuring the compliance with local safety regulations.
1.7 Safety instructions for the owner/operator
Leakages (e.g. due to ruptures in the lining) of hazardous substances (e.g. toxic or
abrasive) must be discharged in such a way as to exclude all danger to people and the
environment. Statutory regulations must be observed.
Danger due to electric current must be excluded (for further details, refer to the German
VDE standards as well as local regulations or chapter 1.4).
1.8 Safety instructions for inspection-, maintenance-, and installation work
The owner must ensure that all inspection, maintenance and installation work is under-
taken by authorized and duly qualified personnel who have also studied this Operation &
Maintenance Manual.
The dosing pump must always come to a complete stop before starting any work on the
pump. The procedure specified in this Operation & Maintenance Manual for shutting down
the Dosing/pump/system must be observed without fail.
Dosing pumps or systems in contact with potentially harmful media must be decontami-
nated.
General and Safety Instructions | Operation & Maintenance Instructions TOPAX L1/L4/L5 | 5
WARNING!
WARNING!
WARNING!
Advertisement
Table of Contents
