Gemo DT109PX Installation & Use

GEMO
Attention, Risk of,
Danger, Warning
•
Dimensions
•
Panel Cut-out
•
Display
•
Sensor Type
•
Measuring Scale
•
Resolution
•
Accuracy
•
Control Form
•
Out Output
•
Alarm Output
•
Heat SET
•
Alarm SET
•
Heat Hysteresis
•
Alarm Hysteresis
•
Proportional Band
•
Integral Time
•
Derivative Time
•
Control Period
•
Offset
•
Heating/Cooling
•
Cold. Junc. Comp.
•
Sensor Failure
•
Supply Voltage
•
Power Consumption : < 8VA
•
Humidity
•
Altitude
•
EMC
•
Safety
•
Protection Class
•
Temperature Spec.
•
Weight
•
Torque for screwing : Max. 0.5 N.m
no: normally open
nc: normally closed
DT109PX / DT107PX / DT106PX / DT105PX / DT104PX
AUTO-TUNE PID TEMPERATURE CONTROLLER
High Voltage,
Risk of Electric Shock
TECHNICAL SPECIFICATION
: DT109:96x96, DT107:72x72, DT105/DT106:48x96, DT104:48x48mm
: DT109:91x91, DT107:68x68, DT105/DT106:93,5x45,5, DT104:45,5x45,5mm
: 4 Digits 7 Segment (PV), 4 digits 7 Segment (SV)
: J type T/C
o
: -100 .. 600 C
o
: ± 1 C
: ± 1 % (Over full scale)
: ON-OFF or P, PI, PD, PID - selectable
: Relay (NO + NC), 250VAC, 2A, Resistive load, (optional SSR)
: Relay (NO + NC), 250VAC, 2A, Resistive load, (only NO for DT104)
: Lower Limit .. Upper Limit
: AL.tY = Abs,-Abs; Lo.L .. UP.L
AL.tY = rel, -rel, bnd, -bnd, bn.i, -bn.i; -100 .. +100
o
: 0 .. 50 C (H.Hys); PID is active if set to 0
o
: 1 .. 50 C (A.Hys)
o
: 5 .. 150 C (Pb.C)
: 0:00 .. 30:00 min:sec. (OFF if set to 0:00)
: 0:00 .. 10:00 min:sec. (OFF if set to 0:00)
: 1 .. 200 sec. (Ct)
o
: -100..+100 C (oFFS)
: Heating only
o
: 0 .. 50 C (T/C)
: OUT output is active according to P.Err and Ct parameters in case of
sensor failure, measurement out of range or hardware fails to measure
input signal (OUT output is OFF if Perr is 0). For Alarm look "Alarm Output".
: 100..240VAC, 50-60Hz or (24VDC/AC; isolation voltage: 40VAC max.)
: < 70% (non-condensing)
: < 2000 m
: EN 61000-6-1, EN 61000-6-3 (Only light industrial environment)
: EN 61010-1; Pollution degree 1, measurement category I, (Only light industrial
environment, double/reinforced isolated, non-conductive pollution environment)
: IP20; according to EN 60529
: Operating: 0 .. 50
: < 0.5 kg
Double / Reinforced
Insulation
o
C (H.Set)
o
C (A.Set)
o o
C, Storage -10 C .. 60
NOT CE Mark
Litter
o
C
o
C (no icing)