Installing And Removing The Ssd Module - Clevo W550AU Service Manual

Installing and Removing the SSD Module

SSD Module installation procedure:
1. Turn off the computer, turn it over, remove the battery
(page 2 - 18).
2. Carefully remove the screw
3. The interface adaptor will pop-up, and you can remove it from the computer
2
4. Insert the SSD module (Figure
3
a. b.
1
(page 2 -
(Figure 14a) .
1
14c), and you can tighten the screw
c.
2
Antenna Cable
Pay attention, and be careful not to damage
the antenna cable on the side when installing
the module or interface adaptor.
13), component bay cover (page 2 -
(Figure 14b).
(Figure 14d).
4
d.
3
4

Installing and Removing the SSD Module 2 - 19
Disassembly
Figure 14
SSD Module
11) and 3G
Installation
a. Remove the screw.
d. Remove the interface
adaptor.
c. Install the module.
d. Tighten the screw.

2.Interface Adaptor
3. SSD Module
• 2 Screws