Table of Contents
Advertisement
14
www.aeg.com
Problem
The compressor operates
continually.
The light does not work.
Too much vibration.
The appliance is noisy.
Water flows on the rear plate
of the appliance.
Water flows inside the wine
cabinet.
The temperature in the wine
cabinet is too low or too
high.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
Temperature is set incor‐
rectly.
The room temperature is
too high.
The door is opened too of‐
ten.
The door is not closed cor‐
rectly.
The appliance is not plug‐
ged in.
The circuit breaker tripped
or a blown fuse.
The lamp is defective.
The light button is not op‐
erating.
The appliance is not sup‐
ported properly.
The appliance is not sup‐
ported properly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Products prevent that wa‐
ter flows into the water col‐
lector.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
9.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Refer to "Operation" chapter.
Refer to "Installation" chapter.
Do not keep the door open
longer than necessary.
Refer to "Closing the door"
section.
Connect the appliance.
Turn on the circuit breaker or
change the fuse.
Contact the service.
Contact the service.
Check if the appliance stands
stable.
Check if the appliance stands
stable.
This is correct.
Make sure that products do
not touch the rear plate.
Set a higher or lower tempera‐
ture.
Refer to "Closing the door"
section.
Advertisement
Table of Contents
