Adding Water And Ground Coffee; Water Filtration System - Mr. Coffee EC Series User Manual

Water Filtration System

(Models ECX30 and EXC33 Only)
Congratulations, your coffeemaker includes the
®
MR. COFFEE water filtration system! This carbon-based
water filtration system improves the taste of your
coffee by removing 97% of the chlorine from the
water that you use to brew your coffee.
To insert the water filtration system into your
coffeemaker please follow these steps.
1) Place water filtration disk in the center of the
permanent filter that was included with your
coffeemaker.
2) Place permanent filter with the water filtration disk
on top of it into your removable filter basket.
3) Reattach the removable filter basket on to your
coffeemaker.
4) Close the brew basket to ensure that the filter has
been properly inserted. If the brew basket does
not close properly then repeat Steps 1 – 3 again.
Note: When you are ready to brew coffee. Simply
remove the water filtration disk and insert the
desired amount of coffee into your permanent
filter. Then place the water filtration disk back
on top of the permanent filter and close the
brew basket. Your water filtration disk will
need to be replaced once every 30 days
(approximately 30 brew cycles). Replacement
water filtration disks can be purchased through
your local retailer or by calling 1-800-MR COFFEE
(1-800-672-6333).

Adding Water and Ground Coffee

1) Swing out the brew basket so that it is extended
out from the coffeemaker.
2) Place a MR. COFFEE
filter or a MR. COFFEE
removable filter basket.
3) Add the desired amount of ground coffee
to the filter. Gently shake the filter basket
to level the ground coffee.
4) Reinsert the removable filter basket back on
to the Coffeemaker. Be certain that the filter
is centered in the basket and then close
the lid to the brew basket.
5) Fill the water reservoir with the desired amount
of tap water. See Figure C-1 (for Models EC12,
EC13, ECX20 and ECX23 only).
®
brand 8-12 cup #4 cone style
®
permanent filter in the
Figure C-1
9