Advertisement
19
Flip the two breaker switches on at the power
distribution unit.
21
Verify that the power LED and Fibre link LEDs on
the controller are solid green. The link LEDs
indicate a good connection.
Configuration
23
Use HP StorageWorks Interface Manager
command-line interface or HP StorageWorks
Command View TL to verify detection of the
new controller, and to perform configuration
and firmware updates.
Refer to the HP StorageWorks Interface
Manager and Command View TL User Guide
for detailed procedures.
20
Power on the library.
Verify that power cables are firmly in place.
a.
Press the power button located on the front of
b.
the library.
After several minutes, verify that the current
c.
state of the library appears in the System
State display on the OCP (System On-line
or System Off-line).
22
Close the back door of the library.
Getting help
• HP product information:
http://www.hp.com/go/storage
• HP technical support and phone numbers:
http://www.hp.com/support
• HP StorageWorks Library and Tape Tools
(L&TT) diagnostic software:
http://www.hp.com/support/tapetools
• Interface Manager and HP StorageWorks
Command View TL:
http://www.hp.com/support/cvtl
• HP manuals:
http://www.hp.com/support/manuals
Advertisement
