Table of Contents
Advertisement
Router Installation
1.
Position router bracket and mark hole positions.
Depending on material, drill a pilot hole or use a
bradawl. Mount the router mounting bracket to the
surface using the 2 x No.6 Screws provided.
!
Note: Make sure the 'Maxview Logo' is
horizontal and in the correct orientation.
IMPORTANT - Be careful when placing the Routers
location that it is not too close to other electrical
control devices. Mounting too close can cause the
router to malfunction.
3.
Attach the Wi-Fi antennas to the top connectors.
These are marked 'Wi-FI'. These should be positioned
so they are vertical.
5.
Place the router into the mounting bracket.
The router can be removed from the bracket at any
time to change the SIM card as required.
6.
The installation is now complete. You may
wish to tidy up cable routing to suit your installation.
10
2.
Attach the antenna coaxial cables to the bottom 2
connectors. These are marked 'mobile'. Note the order
of the cables does not matter.
IMPORTANT - To prevent damage take
!
care to ensure the centre pins are
aligned before attaching the connector.
4.
Connect the 12V power lead or the 230V PSU
(available to order separately) and route the lead to
your power source.
The optimum positioning for the WiFi antennas on the
Roam X Router is pointing directly upwards. However,
the unit can be fitted with the antenna at a 45° or 90°
angle, or pointing downwards or forwards.
This may have a small detrimental effect on the
signal strength, which will become more significant
at greater distances from the router. However, for
leisure vehicle applications, this will likely only cause
a negligible drop in performance.
!
Advertisement
Table of Contents
