Reset Pairing - Chacon 34048 User Manual

NOTE: In this case, the motion detection function is disabled. Only the magnetic door sensor will
trigger an alarm.
b) Away mode: Enter your 4-digit code, then press the «2» button. You will hear a «beep» to
indicate that the alarm will enter the «Away» mode after 30 seconds.
NOTE: In this case, if someone opens the door or window equipped with the opening detector or
enters the field of vision of your motion detector, the alarm will be triggered.
c) Emergency mode: Press buttons 1 and 4 simultaneously in an emergency. An alarm will sound
without time limit to scare off intruders.
5. Combining your alarm unit with other accessories
1. Using a screwdriver, open the battery compartment of the main unit.
2. Press and hold the learn button until you hear a «beep». The unit enters pairing mode. (see
diagram point 1)
a. Remote control: Press any button on the remote control. You will hear a «beep» sound to indi-
cate that the pairing was successful.
b. Opening detector with or without code: Separate the two parts of the opening sensor to send a
signal to the main unit. You will hear a «beep» indicating successful coupling.
c. Motion detector: Wave your hand in front of the motion detector. You will hear a «beep» indica-
ting successful pairing.
d. Remote keypad: Press any button on the remote keypad. You will hear a «beep» indicating
successful pairing.
3. To exit pairing mode, press and hold the learn button for 3 seconds. You will hear a double
«beep»
NOTE: A maximum of 32 transmitters can be paired to a main unit.

6. Reset pairing

In order to reset your entire alarm, remove the batteries from your device. Then press and hold the
learning button of your central unit (see diagram point.1). When you reinsert the batteries, you will
hear two «beeps» indicating that the reset was successful.
7. A 100% compatible ecosystem
We have created a 100% compatible alarm system to meet your needs. Here, we offer accessories
that can work alone but also as a kit. This allows you to personalize your alarm and to associate
several accessories but also several alarms between them. For example, when a person triggers
the opening detector, all your alarms will sound. You can deactivate your alarm using the code
units, remote control or the remote keyboard.
EN